1.8 M 500A Car Battery Jump Cable Booster Emergency Cable Line

The connection procedure is as follows:

(1) First clamp the red wire of the start line above the positive pole of the red battery of the “rescue car”.

(2) Then clamp the red wire at the other end over the positive pole of the red battery of the “rescue car”.

(3) Clamp the black wire to the black negative battery of the “rescue car”.

(4) Then clamp the black wire to the black negative battery of the “rescue car”.

(5) Start the engine of the “rescue car” first, and then start the engine of the “rescue car”. If it is found that the rescued vehicle still cannot be started, please check if the metal contact part is in poor contact.

After the engine is started, it is still necessary to remove the start line in order, otherwise it may cause a short circuit.

The procedure for removing the line is as follows:

(1) First remove the “rescue car” black wire.

(2) We remove black wire of “rescue car” again.

(3) Then remove the red wire of the “rescue car”.

(4) Finally, the red wire of the “rescue car” is removed.

Instructions:

The battery line can be purchased in the auto parts market.

The battery line is usually black and red, which is mainly used to distinguish the positive and negative poles.

When you are riding a car, there is no need to start the vehicle on the electric side.

You only need to connect the batteries of the two cars in parallel.

The red line is added to the positive pole of the two cars,

and the black line is connected to the negative pole of the two cars. The vehicle is gone.